Table Assembly Instructions
1135 Rogers Lake Road
Kila, Montana 59920
contact us at:
406-752-3361
info@buffalotrailartworks.com
1. Parts for assembling your table base.
2. On a solid surface, place a side board on each side of one leg.
3. Fit corner brace over bolt and into slots on side board.
4. Place washer over bolt and thread wing nut on until it contacts corner brace. Do not tighten down the wing nut yet.
5. Continue with next leg and side board until all legs and sides are in place. Hand tighten wing nuts.
6. Set table base in upright position and check that sides and tops of legs are flush. If not, loosen wing nut slightly and move sides until flush Tighten wing nuts.
7. Insert screws through corner bracket and into the pre-drilled holes in the side boards and tighten.
8. Lay table top upside down and place table base on top. Center base on marks and insert top anchors into slots in sides.
9. Screw anchors into pre-drilled holes until snug. Do NOT over tighten screws.
Print this page for your directions to assemble your table base and attach the table top.
Copyright©1995-2008 Buffalo Trail Artworks. All rights reserved.
